Runnymede Motor Company

RMI logo
Trust My Garage logo

Runnymede Motor Company

Servicing

ERAL CHECKS Interim 6.000 Miles or 6 Month Full 12.000 Miles or 12 Month Major 24.000 Miles or 24 Month
Check bodywork for damage and number plate condition.
Conduct road test of vehicle and report if necessary.
Check wipers and washers condition and operation (align jets and top up if required).
ELECTRICAL
Check operation of external lights.
Carry out battery test and print result, lubricate connections.
Visual inspections of HT (high tension) leads.
Check headlamp alignment.
Check dashboard warning lights.
Check glow/heater plug warning lamp where fitted.
Check alternator output and check security.
Test starter motor cranking operation and security.
INTERNAL INSPECTION
Lubricate door hinges and catches.
Replace pollen / cabin filter.
Check seatbelt operation.
Check air conditioning operation. (if applicable)
ENGINE
Add Premium Engine Flush – perform engine running to clean oil system and drain oil.
Replace engine oil with fresh Premium Fully Synthetic Oil as per engine oil car specification of particular model/engine.
Replace oil filter.
Replace air filter.
Replace fuel filter (if external from tank) *
Check and advise on excessive oil leaks.
Check coolant level and top up if required.
Check radiator and hoses condition.
Check coolant cap seals.
Check cooling fan for operation where applicable.
Check for unusual engine noise.
Check condition and adjust auxiliary drive belts if required (excluding timing belt)
Replace spark plugs (petrol engines only)*
Check and record antifreeze strength and minimum temperature and top up coolant as required.
Drain out cooling system and replace coolant to correct specification.
Check condition and security of undertray.
BRAKES
Check brake pads for wear or damage.
Check brake servo operation.
Visually check brake calipers / hoses / and cylinders. (security leaks and wear)
Check brake fluid boiling point. (top up if required)
Replace brake fluid and bleed system.
Check operation of handbrake. (adjust if required)
Check brake discs and drums for wear, cracks, corrosion and scoring or pitting (excluding internal drums).
STEERING – SUSPENSION
Check power steering fluid.(top up if required)
Check visually condition road springs.
Check steering / suspension components for wear and corrosion.
Check steering rack gaiters, CV boot condition.
Check visually shock absorbers and mountings function.
Grease prop shaft and suspension joints (if applicable)
Check wheel bearings (noise/roughness and play)
Check gearbox mount (where possible)
Check sway bars, links, tie rods & bushes.
FUEL SYSTEM
Check fuel lines for security / leaks / condition.
Check fuel flap function breathers and cap.
Check visually fuel tank straps and security.
DRIVE SYSTEM
Check for correct clutch operation.
Check clutch fluid level (if applicable).
Check for correct gearbox operation.
Check drive shafts and gaiters security leaks.
Check gearbox fluid level and top up where applicable and not sealed.
Check for transmission oil leaks.
Grease prop/shaft if applicable.
Check and top up axle and/or transaxle oil if applicable.
Check clutch cable (if applicable).
EXHAUST
Inspect exhaust system including catalyst if fitted for leaks and noise.
Visual check for exhaust smoke.
TYRES – WHEELS
Remove road wheels.
Check tyre condition and tread depth including spare.
Check and adjust tyre pressures.
Check for uneven wear and report if Wheel Alignment / Tracking.
Run check through Aligner Machine if wheel alignment needed.
FINAL CHECKS
Refit road wheels to manufacturers torque specification.
Check for timing belt (cambelt) replacement interval and report if replacement due according to a mileage or age
Perform computer diagnostic test and report accordingly.
Reset vehicle service light where applicable.
Stamp service book (According to which service has been performed).
Complimentary Mini Valet.
Top